Parkside Performance PBSPA 12 E4 Bedienungsanleitung Und Originalbetriebsanleitung Seite 19

˜ Checking the battery pack's
charging level
(Fig. A)
1. Unlock the on/off s itch
pressing the rotation direction
switch towards the left or right.
6 ] [
2. Brie y press the on/off s itch
charging level
approx. 10 seconds after releasing
the on/off s itch.
Colour
Red/orange/green
Red/orange
Red
˜ Charging the battery pack
WARNING! Risk of injury!
m
Al ays unplug the charger
from the mains before inserting/
removing the battery pack
NOTE
ou can charge the battery pack
u
at any time without reducing its life
cycle.
Interrupting the charging process
u
does not damage the battery
pack .
[ ]
et the charger
u
for at least 15 minutes bet een
successive charging processes.
(Fig. A)
Before operation: Charge the battery
o
pack when it is at medium or low
[ ]
charging level (see "Checking the
battery pack's charging level").
The charging control LEDs (green
o
and red ) indicate the status of the
[ ]
charger and the battery pack
[ ]
by
8 ] [
. The
[ 8 ]
Ds light up for
9 ] [
Charging level
Maximum
Medium
Low
[ ]
.
[ ]
[
cool down
[ ]
[
:
[ ]
LED
ed D lights up Battery pack
[ ]
reen D
[
up
reen D
[
red D ashing
[ ]
ed D ashing
[ ]
reen D
[
up (without battery
pack )
[ ]
1. Insert the battery pack
charger .
[ ]
2. Connect the mains plug
charger
[ ]
3. When the battery pack
charged:
– Disconnect the mains plug
the charger
outlet.
– emove the battery pack
the charger
˜ Attaching/removing the
]
accessory tool
CAUTION! Risk of injury!
m
Accessory tools can be sharp
and may become hot during use.
Always wear protective gloves
when handling accessory tools!
WARNING!
m
Al ays s itch the product off
remove the battery pack
and let the product cool down
before making any adjustments!
]
Status
charges
lights Battery pack
]
fully charged
and Battery pack
]
defective
Battery pack
too cold or too
warm
lights
]
harger
[
ready
into the
[ ]
of the
[ ]
to a mains outlet.
is fully
[ ]
[
from the mains
[ ]
[
.
[ ]
[
[ ]
[ ]
[ ]
[ ]
]
of
]
from
]
]
GB 17