Parkside Performance PBSPA 12 E4 Bedienungsanleitung Und Originalbetriebsanleitung Seite 20

CAUTION! Risk of injury!
m
Keep your hands away from the
u
accessory tool when the product is
in operation.
After the product has been
u
s itched off the accessory tool
continues moving for some time.
Do not touch the accessory tool
and do not attempt to brake it.
( ig. )
This product is equipped with an
automatic spindle lock to open or close
the chuck with the chuck ring
[ 1 ]
1. Open the chuck
ring in a counter-clockwise
[ 2 ]
direction.
2. Insert a suitable accessory tool
(scre bit ood drill bit
[ ]
SS drill bit ) into the chuck
[ ]
deep as required.
3. Close the chuck
accessory tool in position.
Turn the chuck ring
clockwise direction.
˜ Removing/installing the
chuck
NOTE
If you want to use the bit
u
adaptor (see "Using the bit
[ ]
adaptor ) you must rst remove the
chuck .
1 ] [
(Fig. H)
Removing the chuck
1. old the chuck
2. Pull the lock ring
unlock the chuck
3. Pull the chuck
1 ] [
adaptor .
[ ]
18 GB
.
2 ] [
: Turn the chuck
1 ] [
, or
[ ]
as
1 ] [
: Hold the
[ 1 ]
in a
2 ] [
from the front.
[ 1 ]
backwards to
[ 3 ]
.
[ 1 ]
off the bit
Installing the chuck
NOTE
f the chuck
u [ 1 ]
adaptor do not properly engage,
[ ]
the lock ring
[ 3 ]
to its initial position. In this case,
rotate the chuck clockwise or
counter-clockwise until the lock ring
returns back to its initial position
with a click sound.
1. Pull the lock ring
2. Align the hole of the chuck
the bit adaptor
[
3. Push the chuck
adaptor as far as it will go.
[ ]
4. elease the lock ring
chuck .
[ 1 ]
˜ Using the bit adaptor
NOTE
If you want to use the bit
u
adaptor you must rst remove
[ ]
the chuck (see "Removing/
[ 1 ]
installing the chuck").
(Fig. J)
nsert a scre bit
o
adaptor as far as it will go. The
[ ]
screw bit is held in place by a magnet
at the bottom of the bit adaptor.
To remove the scre bit
o
of the bit adaptor
˜ Trial run
NOTE
Always carry out a no-load trial run
u
before starting work and after every
accessory tool replacement. Switch
the product off immediately if the ac-
cessory tool is not running smoothly,
if considerable vibration occurs or if
you hear abnormal noises.
and the bit
cannot return back
backwards.
[ 3 ]
with
[ 1 ]
.
]
onto the bit
1 ] [
to secure the
3 ] [
into the bit
[ ]
, pull it out
[ ]
.
[ ]