Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Symptom
-
Cannot select
Nav mode
-
-
-
Autotack
function not
-
working
-
-
Pilot does not
hold accurate
course in Auto
mode
These simple checks should be carried out before seeking technical
assistance and may save time and expense. Before contacting your
servicing agent, please note the Tillerpilot's serial number.
Appendix |
TP10, TP22 & TP32 User Guide
Probable Cause
GPS/Chart Plotter
not connected
Waypoint not
active
Wrong NMEA
format is being
used
Pilot is in Nav Mode
Pilot is in Steer To
Wind Mode and
a) apparent wind is
>90º
b) autotack being
attempted is in the
wrong direction
Fluxgate compass
is being affected by
interference from
nearby magnetic
influences (binnacle
compass, speakers)
or metallic objects
(winches, deck
hardware etc).
Remedy
-
Check connections
-
Activate waypoint/
route
-
Check NMEA 0183
format is being
transmitted by
navigational receiver.
-
Exit Nav Mode
-
Luff up until
apparent wind is less
than 90º.
-
Check compass has
been calibrated
("Auto compass
calibration" on page
22).
-
Fit external SimNet
compass.
-
Replace binnacle
compass
-
Relocate objects
that are causing
interference.
| 25
Werbung
