Simrad TP10 Handbuch Seite 49

Configuring the TP on the SimNet bus
Normally the TP22 and TP32 can be connected to the SimNet bus
and will automatically share data sources with other SimNet units
without any required user intervention.
Display
Compass
Two operation modes are available:
System mode
(default)
StandAlone mode
To change the mode, first turn off the Tillerpilot
-
To select System mode (default), press and hold the
STBY/AUTO
and
Installation | TP10, TP22 & TP32 User Guide
Autopilot
The Tillerpilot automatically shares data
sources with other SimNet units.
Source selection can be done from any
SimNet unit using shared data resources
The Tillerpilot will not automatically share
data sources with other SimNet units,
other than AP24 or AP28 control units
included in the system. These will always
share data sources with the Tillerpilot.
The data sources for the Tillerpilot and
the AP24/AP28 can be selected from the
AP24/AP28 control unit.
NAV
keys while turning power on
GPS/Chartplotter
TACK,
| 19