Connection Of Power Circuit; Terminal Strip X1A; Wiring Instructions - KEB COMBIVERT F5 Installationsanleitung

Installation and Connection
3.3

Connection of Power Circuit

3.3.1

Terminal Strip X1A

Terminal strip X1A/ 230 V class suitable for
• 180...260 V AC / 1-phase (L1/N)
• 180...260 V AC / 3-phase (L1, L2, L3)
• DC supply 250...370 V DC (++,- -)
• ++, PB Braking resistor
• U, V, W Motor
• T1, T2 Temperature sensor / switch (see chapter 3.3.6)
3.3.2

Wiring instructions

Absolutely observe the connecting voltage of the KEB COMBIVERT. A 230V-unit will
be immediately destructed on a 400V-power supply.
Never exchange the mains and motor cables.
Some countries demand that the PE-terminal is directly connected to the terminal
box (not over the mounting plate).
Separate supply of the control
Without further cooling measure a separate supply of the control is not permissible
during a longer period, because the interior fan is not controlled here. The occuring
heat accumulation causes an accelerated aging of the components and thus for a
reduction of the economic life time.
12
Terminal strip X1A/ 400 V class suitable for
• 305...500 V AC / 3-phase (L1, L2, L3)
• DC supply 420...720 V DC (++,- -)