KEB COMBIVERT F5 Installationsanleitung Seite 54

CP-Parameter
CP.28 Display
0 E.dOH
1* A.dOH
2* A.dOH
3 A.dOH
4* A.dOH
5* A.dOH
6* none
7 none
*) If the motor is still too hot after 10 seconds, the error E.dOH is triggered and the
modulation is switched off!
CP.29 Analog output 1 / Function
CP.29 defines the function of analog output 1.
Value Function
0 Absolute actual frequency CP.3
1 absolute set frequency CP.2
2 actual frequency CP.3
3 set frequency CP. 2
4 output voltage CP.9
5 DC link voltage CP.7
6 apparent current CP.4
7 active current ru.17
8...10 only application mode
11 absolute active current ru.17
12 power stage temperature ru.38
13 motor temperature ru.46
14...18 only application mode
19 ramp output frequency ru.2
20 absolute ramp output frequency ru.2
CP.31 Relay output 1 / function (terminals X2A.24...26)
CP.32 Relay output 2 / function (terminals X2A.27...29)
The switching level of CP.31 is pre-set to 100,00.
The switching level of CP.32 is adjusted by CP.33!
Value Function
0 No function (generally off)
1 Generally on
2 Run signal; also by DC-braking
3 Ready signal (no error)
4 Fault relay
5 Fault relay (without auto-reset)
GB - 26
Response
Immediate disabling of modulation
Quick stop / disabling the modul. after reaching
speed 0
Quick stop / holding torque at speed 0
Immediate disabling of modulation
Quick stop / disabling the modul. after reaching
speed 0
Quick stop / holding torque at speed 0
No effect to the drive; With CP.31/32 an external
module can be controlled (e. g. fan)
No effect to the drive; Malfunction is not present!
External temperature monitoring is not activated.
Restart
Remove fault;
reset
Autoreset, if no
fault is present
inapplicable
Scaling factor
0...100 % (0...±100 %)
0...100 Hz
0...100 Hz
0...±100 Hz
0...±100 Hz
0...500 V
0...1000 V
0...2 • rated current
0...2 • ±rated current
0...2 • rated current
0...100 °C
0...100 °C
0...±100 Hz
0...100 Hz