Electric Connection - Scheppach 4906705000 Anleitung

45° diagonal cutting (Fig. 8)
1 Set angled stop (6) to 45°
2 Carry out cutting as described.
45° longitudinal cutting, (Fig. 9)
1 Loosen the star knob screw (E) on both sides
2 Slant guide rail (8) at the left to 45° of the angle
scale (18).
3 Tighten the star knob screw (E) again.
4 Perform cutting as described.
changing diamond cutting disc (Fig. 10- 11)
caution! Disconnect power plug
1 Loosen the 2 bolts (F) and take out the saw blade
protection (20). (Fig.10)
2 Place the wrench (21) on the motor shaft and keep
it there.
3 Loosen the flange nut in the running direction of the
cutting disc (10) with the wrench (22).
4 Remove the outer flange (23) and cutting disc (10).
(Fig.11)
5
Clean the supporting flange carefully before installing
the new cutting disc.
6 Insert the cutting disc in the reverse sequence and
tighten it.
caution: Pay attention to the running direction of the cut-
ting disc!
7 Reinstall the saw blade protection (20).
Transport
caution! Disconnect power plug
To transport the machine, set the machine head in front
and engage the locking pin (13) (Fig.5)
m Electric connection
Check electric cables regularly for damage. Ensure that
during the check, the connecting cable is not connected
to the mains.
Electric connecting cables must conform to the common
VDE- and DIN provisions. Only use connecting cables
with the H 07 RN designation.
Keeping a copy of the type designation on the connecting
77