Scheppach 4906705000 Anleitung Seite 67

OTHER SAFETy InSTRucTIOnS
Please read all the instructions before using this product!
workplace
To rule out the risk of physical injury, machine damage,
fire and electric shock, please ensure that your workplace
is protected
• against humidity, wetness and rain,
• It is free of Inflammable gases and liquids,
• It is protected from children – use padlocks and the
master switch when the machine is not in use;
• It is clean and empty,
• It is well-ventilated and illuminated.
The operators
Healthy commonsense and caution are factors that can-
not be integrated in a machine. These factors are the res-
ponsibility of the operator. Please consider the following:
Prevent body contact with grounded surfaces such as
pipes and radiators.
Please be watchful. Do not work at the machine if you
are tired.
Do not operate the product under the influence of alco-
hol or drugs. Read the warning instructions to determine
whether your judgement or your reflexes could be affec-
ted.
Do not wear loose clothing or ornaments which can get
entangled in rotating components.
Anti-skid shoes are recommended.
Protect long hair with suitable means.
Wear eye- and ear protection. Always wear:
• ANSI- approved dust masks.
• Hearing protection.
Always maintain your balance.
Do not stretch yourself over running machines.
m Proper use
The machine corresponds to the valid Eu machine Directive
• Before starting work, all the protection- and safety de-
vices must be installed on the machine.
• The machine is designed for operation by one person.
The operator will be responsible for the presence of
third persons in the work area.
• Observe all safety- and danger instructions on the ma-
chine.
• Keep all safety and danger instructions near the ma-
chine in complete and readable form.
• The machine is designed exclusively for cutting small
and medium-sized tiles (glazed, ceramic or similar ti-
les) with the offered tool and accessories. Cutting of
metal and wood is not allowed.
• The dimensions of the workpieces to be machined
should not exceed or fall below the specified maxi-
mum and minimum dimensions.
• Please use the machine only if it is in a technically
fault-free condition. Use It properly, conscious of the
involved safety and risk factors and giving due consi-
deration to the operating instructions manual! Faults,
especially those that can affect safety must be recti-
67