Pkm IN4-DA-2FZA++A Bedienungsanleitung Seite 133

indicator of the linking function «
on.
2. When one or more cooking zones are activated, the extractor fan is now activated
automatically at the same time. By default, the power level of the extractor fan
corresponds to the currently set highest power level of all activated cooking
zones.
1. The linking function must be switched on. On the display, the operational status
indicator of the linking function «
2. When one or more cooking zones are activated, the extractor hood opens
automatically. By default, the power level of the extractor corresponds to the
currently set highest power level of all activated cooking zones.
3. Touch the « O
N
extractor fan setting mode. Now use the sliding sensor to set the desired power
level of the extractor fan in relation to the cooking zone with the currently set
highest power level.
1. The currently activated cooking zone is set to power level «
power level that is currently set. All other cooking zones are either deactivated or
set to lower power levels.
2. The extractor fan should work with a difference of 2 power levels to the power
3
level « » of the activated cooking zone: i.e. with power level «
3. Touch the « O
N
extractor fan setting mode. Now set the power level «
4. When the extractor is switched off, the difference of 2 power levels is saved and
carried out again as soon as a cooking zone is started with the linking function
activated.
5. The difference of 2 power levels is always retained. If you change the power level
of the cooking zone with the highest setting, e.g. here from «
level of the extractor fan is automatically adjusted and set to power level «
H
OW TO ADJUST THE LINKING FUNCTION
/ O » - (extractor fan) «
FF SENSOR
E
/ O » - (extractor fan) «
FF SENSOR
» goes on. The linking function is switched
» is on.
» once briefly to activate the
XAMPLE
» once briefly to activate the
3
». This is the highest
5
».
5
» using the sliding sensor.
3 5
» to « », the power
7
».
~ ~
133