Assignment Of The Bus Module Ip Address; Displaying The Bus Module Ip Address; Deleting Ip Settings And Device Names - Fronius Ri Fb Pro/I Bedienungsanleitung

Assignment of the Bus Module IP Address

Assignment of
the Bus Module
IP Address
Displaying the The IP address of the bus module assigned by the master can be viewed on the
Bus Module IP website of the welding machine. Proceed as follows in order to do this.
Address
Note down the IP address of the welding machine source used:
1
2
3
4
Access website of the welding machine in the internet browser:
5
6
7
Display IP address of the bus module:
8
9
Deleting IP Set- The two options listed below are available for the deletion of the IP settings and
tings and Device the device name.
Names
Using the DIP switch:
1
2
On the welding machine website:
1
On the welding machine control panel, select "Presets"
On the welding machine control panel, select "System"
On the welding machine control panel, select "Information"
Note down the displayed IP address (example: 10.5.72.13)
Connect computer with the network of the welding machine
Enter the IP address of the welding machine in the search bar of the Internet
browser and confirm
Enter standard user name (admin) and password (admin)
- The website of the welding machine is displayed
On the welding machine website, select the "RI FB PRO/i" tab
The current IP address is displayed under the "Fieldbus configuration" point.
For example: 192.168.0.12
Switch all positions on the DIP switch to OFF (position 1–6)
Restart interface
(disconnect power supply and then reconnect again)
Select the "RI FB PRO/i" tab on the power source website
Englisch (US)
In the case of ProfiNet, the assign-
ment of the IP address, the subnet
mask, and the default gateway is carri-
ed out by the master. A device name is
also assigned to the interface by the
master.
Therefore the IP address cannot be set
via the DIP switch.
The communication takes place via the
IP address assigned by the master.
27