Setting The Ip Address; The Website Of The Power Source; Opening And Logging Into The Smartmanager For The Power Source - Fronius Ri Fb Inside/I Bedienungsanleitung

Setting the IP Upon delivery the node address is set to 0 using the dip switch.
Address
This corresponds to the following IP settings:
-
-
-
The IP address can be configured in two ways:
-
-
NOTE!
If the IP address is again set to higher than 0 with the dip switch, the relevant IP
address will be configured to the range of 1 to 63 after restarting the robot in-
terface.
A node address previously configured by a configuration tool is overwritten.
NOTE!
If configurations have already been made, the network configurations can be
restored to factory settings in two ways:
▶
▶
The Website of
The power source has its own website, the SmartManager.
the Power As soon as the power source has been integrated into a network, the SmartMana-
Source ger can be opened via the IP address of the power source.
Depending on the system configuration and software upgrades, the SmartMana-
ger may contain the following entries:
-
-
-
-
-
-
-
-
Opening and
Logging into the
SmartManager
for the Power
Source
1
34
IP address: 0.0.0.0
Subnet mask: 0.0.0.0
Default gateway: 0.0.0.0
Using the DIP switch within the range defined by 192.168.0.xx
(xx = DIP switch setting = 1 to 63)
If the dip switch is set to 0, using the following configuration tools:
- Using the website of the power source
set all dip switches back to 0
with the button Restore factory settings on the website of the power source
Overview
Update
Screenshot
Save and restore
Function packages
Job data
Overview of characteristics
RI FB INSIDE/i
3
1
Presettings/System/Information ==> note down IP address of power source
2
1.9.0-16501.9508
xx.x.xxx.x
4