Maintenance Of Cutting Tables; Lubricating The Cutting Table - struers Discotom-6 Gebrauchsanweisung

Maintenance of Cutting Tables

Lubricating the Cutting Table

Spindle
26
Discotom-6
Instruction Manual
The stainless steel bands should be replaced if they become worn or
damaged. The bands are available as spare parts.
To allow humidity to escape from the cutting table and chamber, it is
recommended to leave the hood open when the machine is not in
use.
To maintain the optimum performance of Discotom-6, lubricate the
cutting table at regular intervals (approx every 50 hours).
Check the service counter on the right hand side of the machine
regularly to monitor the actual number of usage hours.
After lubrication, note the date and number of service hours on the
Maintenance Log table.

Move the cutting table to its rear position using the 
BACKWARDS key.

Place the grease gun on the nipple in front of the spindle for the
cutting table and push twice to grease the spindle.
A grease gun with grease for lubricating the Y-table spindle is
supplied with the Discotom-6.
When all the grease has been used, refill the grease gun.
Grease Nipple
for Spindle