Trouble-Shooting - struers Secotom-10 Gebrauchsanweisung

Error
Software message
Secotom-10
Instruction Manual

4. Trouble-Shooting

Message
Cannot start, cover is open
Process stopped,
cover is open.
Close cover to continue
Feed board is stuck, remove
obstacles
Main motor overload, cutting stopped Reduce feed speed, or replace cut-
Feed reduction off, feed speed is at
minimum
Select "Cutting" before starting
Initialising, please wait...
Main motor overheated, cooling
down
Motor communication failure
Feed reduction too high, cutting
stopped
Feed speed was reduced to
X.XXmm/s
No AUTO cut length when wheel
speed < 750 rpm
Action
Close cover and press START again.
Close cover to continue the process.
Check area around Y-table for
obstructing objects. Press Ok to
remove error message.
off wheel. Press Ok to remove error
message.
Feed speed reduced to smallest
possible value, 0.005mm/s.
Go to the main menu and select
"Cutting" in order to start cutting.
Motor controller communication is in
progress, wait a moment. Error
message is removed when
communication is Ok.
Wait for main engine to cool down,
Press Ok to remove error message.
Motor controller communication
failure, try again. If the problem
persists, the unit must be serviced.
Press Ok to remove error message.
Feed speed reduced to below 50%
of starting value, cutting is aborted.
Press Ok to remove error message.
Shown after a cutting is finished, if
feed speed was reduced. Press Ok
to remove error message.
Shown when START is pressed, if
AUTO cut length has been selected
with a wheel speed of less than 750
rpm. Either set a manual cut length,
or select a wheel speed of at least
750 rpm. Press Ok to remove error
message.
37