Getting Started; Checking The Contents Of The Packing Box; Removing Secotom-10 From The Pallet; Placing Secotom-10 - struers Secotom-10 Gebrauchsanweisung

Checking the Contents of the
Packing Box
Removing Secotom-10
from the Pallet

Placing Secotom-10

Cover for Exhaust Hole

2
Secotom-10
Instruction Manual

1. Getting Started

In the packing box you should find the following parts:
1 Secotom-10
2 Mains cables
1 Stop pin
1 Socket spanner 17 mm
1 Socket spanner 13 mm
1 Hose for connection to exhaust, 1.5 m x 32 mm dia.
1 Hose clamp, 25-40 mm dia
1 Cover for exhaust hole
1 Instruction Manual Set
Secotom-10 is secured to the wooden pallet with 3 screws. Remove
these screws with a 13 mm socket spanner.
Secotom-10 should be placed on a safe and stable support table with
an adequate working height. The table must be able to carry at least
55 kg. The machine must be placed close to the power supply.
The exhaust pipe at the back of the cutting chamber can be replaced
with the cover for the exhaust hole if Secotom-10 is not to be
connected to an exhaust system.