Setting Feed Speed - struers Secotom-10 Gebrauchsanweisung

Setting Feed Speed

24
Secotom-10
Instruction Manual

Use the Arrow buttons

controls the speed with which the cutting table moves

towards the cut-off wheel.

Press ENTER

Use the Arrow buttons
and hold if a large range change is necessary.
If the feed speed setting is incorrect: a high feed speed may result in the
load being too great on the cut-off wheel and a low feed speed may result in
problems when using the "Auto" cut length
Material Cut-off wheel
Al203
Hardened steel
HRC 60
Stainless steel
Steel HRC 45
0,5% C-steel
Titanium
*Wheel speed reduced below the recommended value because of the

to select "Feed speed". This

to display the popup box.

to change the setting. Press
Important
Feed speed
mm/sec.
M1D20 1.00
50A20 0.35
50A20 0.20
30A20 0.35
30A20 0.40
10S20 0.25
materials hardness.
Recommended
Wheel speed
rpm
3000
2500*
3000
3000
3000
2500