Setting Cut Length - struers Secotom-10 Gebrauchsanweisung

Setting Cut Length

Auto
Fixed Length
Secotom-10
Instruction Manual
"Cut length" defines when the cutting process is finished. When the
cut length is achieved, the cut-off wheel will stop.

Use the Arrow buttons




Press ENTER
Use the Arrow buttons
and hold if a large range change is necessary.

Note: There are two types of settings here:
Auto (use as standard method) and
Fixed length (use when problems occur).
Auto stops the cutting process when the piece has been cut through.
Can be selected by selecting the value above or below the possible
cut length.
Auto stop is not available when a Clamping Tool
with rotation or oscillation is used.
Fixed Length stops the cutting process when the cutting table has
travelled the specified distance. This method is used for cutting
hollow pipes and work pieces with irregular hardness or cross-
sections.

Push Enter to display the popup box and use the Arrow

buttons
When the specified cut length setting is achieved, the

cutting table returns to its start position.
Auto uses the change in resistance (or loading) of the cut-off wheel motor to
determine when the specimen is cut through.
When cutting hollow tubes or irregular materials where the resistance may
vary, it is recommended to use Fixed Length.

to select "Cut length".

to display the popup box.

to change the setting. Press
Note
to change the setting.
Important Note
25