Stopping The Cutting Process - struers Secotom-10 Gebrauchsanweisung

Stopping the
Cutting Process
30
Secotom-10
Instruction Manual

When the specified cut length is reached, the cut-off wheel will
automatically stop rotating and the cutting table will return to its
start position.
The cutting process can be stopped at any time by pressing the STOP
button

If the machine has been stopped with the STOP
cutting table will stay in position. To return the cutting table to its
start position, press the joystick downwards once. Please note
that the protection guard has to be closed in order to carry out
this operation. If the protection guard has been opened, press
and hold the joystick down to move the cutting table to its start
position.

If the cutting table reaches the back of the cutting chamber
during the cutting process, the cut-off wheel automatically stops
and the cutting table returns to its start position.
Note: the cutting table can be positioned by moving the joystick up or
down.
IMPORTANT

on the Control Panel.

key, the