struers Secotom-10 Gebrauchsanweisung Seite 3

Secotom-10
Instruction Manual
Secotom-10
Safety Precaution Sheet
To be read carefully
before use
1. The operator should be fully aware of the use of the machine according
to the Instruction Manual and the instructions of the cut-off wheels.
2. The machine must be placed on a safe and stable support table. All
safety functions and guards of the machine must be in working order.
3. The unit must be installed in compliance with local safety regulations.
4. Use only intact cut-off wheels. The cut-off wheels must be approved for
min. 5,000 rpm.
5. When the manual cutting table is used, the machine is not to be used
with saw-blade type cut-off wheels.
6. Observe the current safety regulations for handling, mixing, filling,
emptying and disposal of the additive for cooling fluid.
7. To achieve maximum safety and lifetime of the machine, use only
original Struers consumables.
8. Struers recommends using cooling fluid when cutting as the materials
being cut may emit harmful dust. Additionally an adequate exhaust
system should be used.
9. The machine emits only moderate noise. However, the cutting process
itself may emit noise, depending on the nature of the workpiece. In
such cases, the use of hearing protection is recommended.
10. Always use Safety Goggles when using the manual cutting table on the
machine.
11. The machine must be disconnected from the mains prior to any service.
Wait until residual potential on the capacitors is discharged.
12. Do not cycle mains power more than once every three minutes.
Damage to the drive will result.
The equipment should only be used for its intended purpose and as detailed in the Instruction Manual.
The equipment is designed for use with consumables supplied by Struers. If subjected to misuse, improper
installation, alteration, neglect, accident or improper repair, Struers will accept no responsibility for
damage(s) to the user or the equipment.
Dismantling of any part of the equipment, during service or repair, should always be performed by a qualified
technician (electromechanical, electronic, mechanical, pneumatic, etc.).