Comfee Smart Cool 7000 Plus Benutzerhandbuch Seite 29

E4-Display panel communication error. Shows protection code:
P1-Bottom tray is full--Connect the drain hose and drain the collected water away. If protection repeats, call for service.
NOTE:
When one of the above malfunctions occurs, turn o the unit, and check for any obstructions. Restart the unit, if
the malfunction is still present, turn o the unit and unplug the power cord. Contact the manufacturer, its service agents
or a similar qualified person for service.
5.FAN function
Press to control the fan speed in three steps HIGH, LOW and AUTO. The fan speed indicator light illuminates under di erent fan settings.
6. COOL mode
Press the "MODE" button until the "Cool" indicator light comes on.
Press the ADJUST buttons "+" or "-" to select your
7. DRY mode
Press the "MODE" button until the "Dry" indicator light comes on. In this mode, the fan speed or the temperature cannot be adjusted. The fan
motor operates at LOW speed.
NOTE:
Keep windows and doors closed for the best dehumidifying e ect. Do not put the duct to window.
8. AUTO mode
Press the "MODE" button until the "Auto" indicator light comes on. In this mode, the fan speed or the temperature will be adjusted automatically.
9 Other features
FOLLOW ME/TEMP SENSING feature (On some models)
This feature can be activated from the remote control ONLY. There is no indicator light on the control panel. The remote control serves as a
remote thermostat allowing for the precise temperature control at its location.
To activate the Follow Me/Temp Sensing feature, point the remote control towards the unit and press the Follow Me/Temp Sensing button. The
remote control will send this signal to the AC until press the Follow Me/Temp Sensing button again. If the unit does not receive
the Follow Me/Temp Sensing signal during any 7 minutes interval, the unit will exit the Follow Me/Temp Sensing mode.
NOTE:
This feature is unavailabe under FAN or DRY mode.
27
EN