Comfee Smart Cool 7000 Plus Benutzerhandbuch Seite 28

Get to know your AC
1. POWER button
Power switch on/o .
Wireless operation(on some models)
Used to initiate the wireless connection mode.
For the first time to use wireless function,
press the POWER button for 3 seconds to
initiate the wireless connection mode . The LED
DISPLAY shows 'AP' to indicate you can set
wireless connection. If connection(router) is
successful within 8 minutes, the unit will exit
wireless connection mode automatically and
the wireless indicator illuminates. If connection
is failure within 8 minutes, the unit exits wireless
connection mode automatically. After Wireless
connection is successful, for some models you
can press MODE and UP (+) buttons at the
same time for 3 seconds to turn o Wireless
function and the LED DISPLAY shows 'OF' for
3 seconds, press MODE button and UP(+) to
turn on Wireless function and the LED DISPLAY
shows 'On' for 3 seconds.
NOTE:
When you restart the wireless
function, it may take a period of time
to connect to the network
automatically.
8
7
6
2
2. MODE function
Selects the appropriate operating mode. Each
time you press the button, the mode is selected
in a sequence that goes from AUTO, DRY, COOL
and FAN, The mode indicator light illuminates
under the di erent mode setting.
NOTE:
In AUTO mode, the FAN
speed will be adjusted automatically.
FRESH operation(on some models)
Press MODE and DOWN (-) buttons at the
same time for 3 seconds to initiate FRESH
feature and the FRESH light illumiantes on
some models, the LED DISPLAY shows 'On' for
3 seconds. The ion generatoris energized and
will help to purify the air inside. Press it for 3
seconds again to stop the FRESH feature and
the FRESH light turn dark on some models, the
LED DISPLAY shows 'OF' for 3 seconds for
some units.
Electronic control operating instructions
3 1
3. UP and DOWN buttons
Used to adjust (increasing/decreasing)
temperature settings in
1°C/2°F (or 1°F) increments in a range
of 16°C/60°F to 30°C/88°F (or 86°F).
NOTE:
displaying temperature in degrees
Fahrenheit or degrees Celsius. To
convert from one to the other, press
and hold the Up and Down buttons
at the same time for 3 seconds.
4. Display
Shows the set temperature while on Cool,
or Auto mode. It shows the room
temperature on DRY and FAN modes.
Shows Error codes:
E0-EEPROM error.
E1-Room temperature sensor error.
E2-Evaporator temperature sensor error.
E3-Condenser temperature sensor error
(on some models).
26
4
5
The control is capable of
EN