Comfee Smart Cool 7000 Plus Benutzerhandbuch Seite 4

WARNING
Installation must be performed according to the
installation instructions. Improper installation can cause
water leakage, electrical shock, or fire.
Use only the included accessories and parts, and
specified tools for the installation. Using nonstandard
parts can cause water leakage, electrical shock, fire, and
injury or property damage.
Make sure that the outlet you are using is grounded and
has the appropriate voltage. The power cord is equipped
with a three-prong grounding plug to protect against
shock. Voltage information can be found on the
nameplate of the unit.
Your unit must be used in a properly grounded wall
receptacle. If the wall receptacle you intend to use is not
adequately grounded or protected by a time delay fuse
or circuit breaker(the fuse or circuit breaker needed is
determined by the maximum current of the unit. The
maximum current is indicated on the nameplate located
on unit), have a qualified electrician install the proper
receptacle.
Do not touch the unit with wet or damp hands or when
barefoot.
If the air conditioner is knocked over during use, turn o
the unit and unplug it from the main power supply
immediately. Visually inspect the unit to ensure there is
no damage. If you suspect the unit has been damaged,
contact a technician or customer service for assistance.
In a thunderstorm, the power must be cut o to avoid
damage to the machine due to lightning.
Your air conditioner should be used in such a way that it
is protected from moisture. e.g. condensation, splashed
water, etc. Do not place or store your air conditioner
where it can fall or be pulled into water or any other liquid.
Unplug immediately if it occurs.
Install the unit on a flat, sturdy surface. Failure to do so
could result in damage or excessive noise and vibration.
The unit must be kept free from obstruction to ensure
proper function and to mitigate safety hazards.
Do not modify the length of the power cord or use an
extension cord to power the unit.
Do not share a single outlet with other electrical appliances.
Improper power supply can cause fire or electrical shock.
Do not install your air conditioner in a wet room such as a
bathroom or laundry room. Too much exposure to water
can cause electrical components to short circuit.
Do not install the unit in a location that may be exposed
to combustible gas, as this could cause fire.
The unit has wheels to facilitate moving. Make sure not to
use the wheels on thick carpet or to roll over objects, as
these could cause tipping.
Do not operate a unit that it has been dropped or damaged.
The appliance with electric heater shall have at least 1 meter
space to the combustible materials.
All wiring must be performed strictly in accordance with
the wiring diagram located inside of the unit.
The unit's circuit board(PCB) is designed with a fuse to
provide overcurrent protection. The specifications of the
fuse are printed on the circuit board, such
as: T 3.15A/250V, etc.
When the water drainage function is not in use, keep the
upper and the lower drain plug firmly to the unit to get rid
of choking. When the drain plug is not in use, keep it
carefully to prevent children from choking.
02
EN