C) Mounting The Rudder System - Reely 1195424 Bedienungsanleitung

c) Mounting the Rudder System

• Figure 3a shows symbols for the rudder (1) and the
rudder linkage lever (2), as well as the servo linkage
lever (3).
During the following assembly of the rudder system,
observe the correct, rectangular alignment of the li-
nage levers to the neutral rudder.
• Push the rudder with the rods into the body of the
boat from below as shown in figure 3b. Put a little
sizing grease into the guide tube for sealing.
• Attach the „Z" of the linkage rod to the servo linkage
lever (figure 3c, item 1).
Place the rudder linkage lever (figure 3c, item 2) on
the rudder linkage as shown in figure 3c.
• Align the rudder, rudder linkage lever and servo lin-
kage lever (see figure 3c) as shown in figure 3a.
Attach the rudder linkage lever to the rudder linkage
with a hexagon socket wrench (figure 3c, item 3).
Shorten the linkage rods at the rod connection (fi-
gure 3c, item 4) so that the linkage is possible as
shown in figure 3a.
Figure 3a
Figure 3b
Figure 3c
33