D) Mounting The Receiver System - Reely 1195424 Bedienungsanleitung

d) Mounting the Receiver System

• Figure 4 shows the steering servo (1), the holder of
the drive battery (2), the drive motor (3), the speed
controller (4; concealed), the receiver (5), the re-
ceiver aerial (6), the sail winch servo (7) and the
connection plug of the speed controller (8).
• Figure 4, item 5 shows a possible installation site
for the remote control receiver. The receiver can be
attached with hook-and-loop tape or a cable tie.
• The receiver aerial (6) can be attached, e.g.
with a small piece of Bowden tube near the receiver
of a 2.4 GHz remote control so that the last three
centimetres of the aerial point straight up.
The receiver aerials for remote controls with 27 or 40 MHz are much longer. For secure reception, they must
be guided outside and attached to the mast.
Important!
The remote control range may be reduced drastically if the receiver aerial is not placed correctly (e.g. if the
aerial is only in the boat's body). In this case, the model can no longer be controlled. Check that the receiver
aerial is placed correctly before every operation.
• Connect the cable of the speed controller and the connection cables of the steering servo and the sail winch to the
receiver. For notes on correct connection, see the operating instructions of the remote control.
• The matching plugs/sockets must be present in the correct polarity at the drive battery and the speed controller. The
matching plug for the rechargeable battery is not part of the delivery, but must be purchased separately (if there is
no matching plug already soldered onto the battery) and soldered on by you as well. When soldering on, observe
the correct polarity (red cable = plus/+, black cable = minus/-).
• The correct function of the motor, sail winch and steering servo is described in the chapter „Model Commissio-
ning".
34
Figure 4