B) Assembly Of Ballast Keel At The Body Of The Boat - Reely 1195424 Bedienungsanleitung

b) Assembly of Ballast Keel at the Body of the Boat

• Figure 2a shows the keel (1) and the ballast (2) and
a washer plus M3 nut for attachment of the ballast
keel (3).
• Push the ballast onto the keel and attach it to the
keel with a washer and M3 nut. The keel can be
placed on the ballast in one position only due to a
tab.
• Install the keel with installed ballast to the boat body
from below as shown in figure 2b.
Attach the keel to the boat fuselage with a washer
and M4 nut as shown in figure 2c.
Ensure good attachment of keel and ballast. The attachment nuts must be secured against coming loose
with a drop of threadlocker varnish. Check before each run if the attachment nuts fit tightly.
To seal the boat body, the area where the keel is inserted must be sealed with silicone sealing mass (figure
2b, dashed line).
32
Figure 2a
Figure 2b
Figure 2c