EINHELL TC-SB 200 + Originalbetriebsanleitung Seite 22

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
Explanation of the symbols used (see Fig. 22)
1. Danger! - Read the operating instructions to
reduce the risk of injury.
2. Caution! Wear ear-muff s. The impact of noi-
se can cause damage to hearing.
3. Caution! Wear a breathing mask. Dust
which is injurious to health can be generated
when working on wood and other materials.
Never use the device to work on any materi-
als containing asbestos!
4. Caution! Wear safety goggles. Sparks ge-
nerated during working or splinters, chips and
dust emitted by the device can cause loss of
sight.
5. Caution! Risk of injury! Do not reach into
the running blade.
6. Blade cutting direction
7. Conditions of the mains connection
8. Power rating
9. Speed
10. Weight
1. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
WARNING!
Read all safety warnings, instructions, illust-
rations and specifi cations provided with this
power tool. Failure to follow all instructions listed
below may result in electric shock, fi re and/or
serious injury.
Save all warnings and instructions for future
reference.
2. Layout and items supplied
2.1 Layout (Fig. 1-21)
1. On/Off switch
Anl_TC-SB_200_PLUS_SPK13.indb 22 Anl_TC-SB_200_PLUS_SPK13.indb 22
GB
2. 2.5 mm hex key
3. Rubber tire
4. Rubber foot
5. Pedestal
6. Extractor socket
7. Lower blade pulley
8. Upper blade pulley
9. Tensioning screw
10. Push-in cover
11. Upper blade guide
12. Side cover
13. Fastening handle
14. Saw table mount
15. Saw table
16. Angle scale
17. Table insert
18. Wing handle for saw table
19. Washer, large
20. Quick-lock lever
21. Eccentric lever for parallel stop
22. Web plate
23. Scale for parallel stop
24. Parallel stop
25. Machine frame
26. Blade
27. Tilt guard
28. 4 mm hex key
29. Adjustment handle for upper blade pulley
30. Wing handle for upper blade pulley
31. Adjustment wheel for blade guide
32. Locking handle for blade guide
33. Stop screw
34. Lock nut
35. Push stick
36. Push stick holder
37. Lateral guide pins, top
38. Grub screw for guide pins
39. Support bearing, top
40. Grub screw for support bearing
41. Bearing unit, top
42. Grub screw for bearing unit
43. Lateral guide pins, bottom
44. Grub screw for guide pins
45. Socket head screw for guide pins
46. Support bearing, bottom
47. Socket head screw for support bearing
48. Hexagon screw for rubber foot
49. Washer for rubber foot
50. Nut for rubber foot
51. Recessed head screw for tilt guard
52. Washer for tilt guard
53. Spring washer for tilt guard
54. Countersunk head screw for web plate
55. Wing nut for web plate
- 22 -
19.12.2023 10:24:40 19.12.2023 10:24:40