Herunterladen Diese Seite drucken

Maxwell MW-3851 Betriebsanweisung Seite 10

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 14
Food dEHydrator
description
1. Base
2. Power switch «I/0»
3. Trays for dehydration
4. Lid
• Do not use the unit near objects filled with water
(such as sink, bath, swimming pool etc.).
• For additional protection you can install a residu-
al current device with nominal operation current
not exceeding 30 mA into the mains; contact
specialist for installation.
SaFEty MEaSUrES
Before using the unit, read these instructions care-
fully. Keep these instructions for future reference.
Use the unit for intended purposes only, as it is
stated in this manual. Mishandling the unit can
lead to its breakage and cause harm to the user or
damage to his/her property.
• Before switching the unit on make sure that your
home mains voltage corresponds to the voltage
specified on unit body.
• Use the unit only for the intended purposes, use
only the attachments supplied with the unit.
• Place the unit on a heat-resistant flat stable sur-
face, away from sources of heat, moisture and
direct sunlight.
• Do not switch the unit on in places where aero-
sols are sprayed or inflammable liquids are used.
• Do not use the unit outdoors.
• When using the unit we recommend to unwind
the power cord to its full length.
• The power cord should not:
– touch hot objects,
– run over sharp edges.
• Check the cord insulation integrity periodically.
• Never use the unit if the power cord or the power
plug is damaged, the unit works improperly or
after it was dropped. Contact an authorized ser-
vice center for all repair issues.
• In order to avoid fire do not use adapters for
plugging the unit in.
• When unplugging the unit, pull the plug but not
the cord.
• Do not touch the power plug with wet hands.
• Never leave the operating unit unattended.
• Continuous operation time of the unit should not
exceed 40 hours. After 40 hours of operation
switch the unit off, unplug it and let it cool down.
• Do not place and do not keep the unit in places,
where it can fall into a bath or a sink, filled with
water, do not immerse the unit into water or other
liquids.
• If the unit was dropped into water, unplug it imme-
diately. And only then you can take it out of water.
• Provide that water does not get into the base
openings.
• Do not allow children to use the unit as a toy.
• This unit is not intended for usage by children
or disabled persons unless they are given all the
necessary and understandable instructions by
a person who is responsible for their safety on
safety measures and information about danger
that can be caused by improper usage of the unit.
• Do not remove the lid during the operation.
• Keep your face and hands away from the open lid
during the operation.
• Do not touch hot surfaces of the unit.
• Trays for dehydration get hot during the opera-
tion of the unit. Allow them to cool before removal.
• Never insert any foreign objects into the unit
body openings.
• For children safety reasons do not leave polyeth-
ylene bags, used as a packaging, unattended.
• Attention! Do not allow children to play with poly-
ethylene bags or film. Danger of suffocation!
• Always unplug the unit after usage or before
cleaning.
THE UNIT IS INTENDED FOR HOUSEHOLD USAGE
ONLY
BEForE USING tHE UNIt For tHE FIrSt tIME
After unit transportation or storage at low tem-
perature it is necessary to keep it for at least two
hours at room temperature before switching on.
– Remove all stickers and packaging elements that
can prevent unit operation.
– Make sure that operating voltage of the unit cor-
responds to voltage of your mains.
– Wash the trays (3) and the lid (4) with warm water
and neutral detergent, dry them thoroughly.
– Wipe the base (1) with a damp cloth and then
wipe dry.
Attention! Never immerse the unit base into water
or other liquids. Provide that water does not get into
the base openings.
USING THE UNIT
Note: During the first operation some foreign smell
from the heating element is possible, this is normal.
– Wash the foodstuffs, dry them and cut into small
pieces.
– Put the foodstuffs on the trays (3) providing
space for hot air circulation between the pieces.
– Install the trays (3) on one another. Install all the
5 trays even if only some of them are loaded
with food.
– Cover the trays with the lid (4).
– Insert the power plug into the mains socket.
– Switch the unit on, setting switch (2) to the «I»
position.
9
ENGLISH

Werbung

loading

Diese Anleitung auch für:

Mw-3851 w