Tekno Point DELFIN DLF-09 Benutzer- Und Installationshandbuch Seite 78

ENGLISH
Interface
The appliance does not work
Does the UI emit mist?
The desired temperature cannot
be changed
Remove the device
Operate as below
4. Press "Air conditioner" to enter the menù
5. Press "
6. Press "Remove device" to remove the conditioner.
Cooling or Heating are not
effective
Bad odor emission
The appliance turns on suddenly
Is steam coming from the
outdoor unit?
Noise similar to gurgling
Noise similar to crunch
TEKNO POINT ITALIA S.R.L. - VIA DELL'ARTIGIANATO 5 - 30020 MARCON (VE) – ITALY TEKNO POINT ITALIA S.R.L. - VIA DELL'ARTIGIANATO 5 - 30020 MARCON (VE) – ITALY
78
Lack of electricity?
Plug detached?
Tripping of automatic circuit
breakers or fuses?
Damaged electrical wiring?
Was there a sudden surge in
voltage?
Is the remote control setting
correct?
Conditioner off
Are the room temperature and
humidity high?
The unit is in AUTO mode
Is a temperature beyond the
regulation range required?
Supply voltage too low?
"
Is the filter dirty?
Has the set temperature been
reached?
Are there open doors or
windows, heat sources or thermal
bridges?
Dry condensate drain siphon
Possible interference such as
power surges, thunderstorms,
electromagnetic waves
Is heating mode active?
Press "Air
Has the appliance just been
conditioner" to
switched on?
enter the menù
Has the appliance just been
switched on or off?
COMMERCIALE@TEKNOPOINT.COM – WWW.TEKNOPOINT.COM COMMERCIALE@TEKNOPOINT.COM – WWW.TEKNOPOINT.COM
MUI_UNITÀ INTERNA DELFIN_Ita_Eng_Fra_Deu_SKY/Rev.00/Data 03.06.2020 MUI_DELFIN_Ita_Eng_Fra_Deu_SKY/Rev.00/Data 03.06.2020
Conditioner on Share the device:
Press "
"Share device"
Press " "
48 65
Wait until it is restored
Check the insertion of the plug
Have the cause of the
intervention checked by qualified
personnel and restore.
Have it replaced by qualified
personnel
Remove voltage from the
appliance and supply it after
waiting for at least 180 sec.
Check the correct setting of the
remote control
It is a natural phenomenon, as
the temperature and humidity
", than press
decrease, the phenomenon
subsides.
The desired temperature cannot
be changed in AUTO mode.
Change the operating mode.
Set a temperature within the
range: 16 ° C-30 ° C
Check that the supply voltage
Check and clean it (see page 14)
To verify
To verify
Put some water in the bowl.
Clean the filter,
Remove voltage from the
appliance and supply it after
waiting for at least 180 sec
It is a normal phenomenon during
defrosting
Press "Remove Inside the exchanger there is a
device" to change of state of a fluid. It is a
remove the normal phenomenon especially
conditioner. immediately after ignition.
It is a normal noise due to the
normal expansion of the
components, accentuated in heat
pump mode.
ENGLISH