On/Off Button; Mode Button - Tekno Point DELFIN DLF-09 Benutzer- Und Installationshandbuch

ENGLISH
Buttons on remote controller
Interface
After connecting the power, the air conditioner will make a sound. Power indicator is ON. After that, you can operate the air conditioner by using
remote controller. In state of turning on, pressing the button on the remote controller, the air conditioner will make a "beep" sound, which means
the signal has been sent to the air conditioner.The display will show the corresponding setting function icons. In state of turning off, light icon will
be displayed on the display of remote controller (If timer on and light functions are set, the corresponding icons will be displayed on the display
of remote controller at the same time).

ON/OFF button

Press this button to turn on or turn off the air conditioner.

MODE button

Press this button to select your required operation mode. You can select Auto, Cool, Dry, Fan and Heat mode.
Remove the device
Operate as below
• When selecting auto mode, air conditioner will operate automatically according to ex-factory setting. Setting temperature can't be
4. Press "Air conditioner" to enter the menù
adjusted and will not be displayed as well. Press "FAN" button can adjust fan speed. Press "SWING" button turn on or turn off the swing
5. Press "
function.
6. Press "Remove device" to remove the conditioner.
• When selecting cool mode, air conditioner will operate under cooling mode. Press " " or " " button to adjust setting temperature. Press
"FAN" button to adjust fan speed. Press "SWING" button to turn on or turn off the swing function.
• When selecting dry mode, the air conditioner will operate in fan1, fan speed can't be adjusted. Press "SWING" button to turn on or turn off the
swing function.
• When selecting fan mode, the air conditioner will only blow, no cooling and no heating. Press "FAN" button to adjust fan speed. Press "SWING"
button to turn on or turn off the swing function.
• When selecting heat mode, the air conditioner will operate in heating mode. Press " " or " " button to adjust setting temperature. Press
"FAN" button to adjust fan speed. Press "SWING" button to turn on or turn off the swing function. (Cooling only unit won't receive heat mode
signal. If setting heating mode with remote controller, press ON/OFF button can't start up the unit).
Note:
• To preventing cold air, after starting up heating mode, indoor unit will delay 1~5 minutes to blow air (actual delay time is depend on indoor
ambient temperature).
• Seting temperature range from remote controller: 16~31°C; Fan speed: auto, quiet, fan1, fan2, fan3, fan4, fan5, turbo, stepless speed.
TEKNO POINT ITALIA S.R.L. - VIA DELL'ARTIGIANATO 5 - 30020 MARCON (VE) – ITALY
58
Conditioner off
Auto
"
Press "Air
conditioner" to
enter the menù
COMMERCIALE@TEKNOPOINT.COM – WWW.TEKNOPOINT.COM
MUI_UNITÀ INTERNA DELFIN_Ita_Eng_Fra_Deu_SKY/Rev.00/Data 03.06.2020
Conditioner on
Cool Dry Fan
Press " "
48
Share the device:
Press " ", than press
"Share device"
Heat
Press "Remove
device" to
remove the
conditioner.