Tekno Point DELFIN DLF-09 Benutzer- Und Installationshandbuch Seite 66

ENGLISH
Interface
4. Tighten the force of the nuts with a torque wrench with torques corresponding to the following
table. To tighten the tube use a sealing counter-key.
Remove the device
5. Once you completed the junctions of both pipes of refrigerant wrap the same , and the jointing
Operate as below
fittings c on the material thermal insulation . Then wrap everything with adhesive tape to fix the
4. Press "Air conditioner" to enter the menù
insulation .
5. Press "
6. Press "Remove device" to remove the conditioner.
TEKNO POINT ITALIA S.R.L. - VIA DELL'ARTIGIANATO 5 - 30020 MARCON (VE) – ITALY TEKNO POINT ITALIA S.R.L. - VIA DELL'ARTIGIANATO 5 - 30020 MARCON (VE) – ITALY
66
Torque wrench
Indoor pipe
Conditioner off
Pipe dimaeter of the hex nut
6 mm
9,52 mm
12 mm
16 mm
19 mm
"
Press "Air
conditioner" to
enter the menù
COMMERCIALE@TEKNOPOINT.COM – WWW.TEKNOPOINT.COM COMMERCIALE@TEKNOPOINT.COM – WWW.TEKNOPOINT.COM
MUI_UNITÀ INTERNA DELFIN_Ita_Eng_Fra_Deu_SKY/Rev.00/Data 03.06.2020 MUI_DELFIN_Ita_Eng_Fra_Deu_SKY/Rev.00/Data 03.06.2020
Open end wrench
Nut
Conditioner on Share the device:
Torsional force (Nm)
Press "
"Share device"
Press " "
48 53
Pipe
", than press
15-20
30-40
45-55
60-65
70-75
Insulating
Press "Remove
device" to
remove the
conditioner.
ENGLISH