Symbols Used - REHM MEGAPULS 250 Betriebsanleitung

Introduction
Typographic
symbols
Safety
symbols
operator. In the event of special requirements, it may be necessary for additional
special conditions to also be taken into account.
If anything is unclear, consult your safety officer or contact REHM's customer service
department.
You should also pay attention to the special notes regarding correct use set out in
the delivery documentation.
National regulations regarding the operation of the unit are valid with no restrictions .
Correct use also covers the observation of the correct measures with regard to
mounting, removal and remounting, taking into service, operation and maintenance
as well as disposal.
Please pay special attention to the specifications in Chapter 2 Safety notes and
Chapter 8.5 Correct disposal.
The unit may only be operated under the conditions set out above. Any other use is
not correct. The consequences are the responsibility of the operator.
1.3

Symbols used


Lists with bullets: General lists
 Lists with a square: Work or operational steps that must be carried out in the
sequence listed.
 Chapter 2.2, Warning symbols on the unit
Cross-references: In this case, to Chapter 2.2 Waning symbols on the unit
Bold is used for emphasis
Note!
... Refers to tips and other useful information.
The safety symbols used in this manual:  Chapter 2.1.
GB
11