Symbols Used; Chapter 2.2, Warning Symbols On The Unit - REHM INVERTIG.PRO 240 DC Betriebsanleitung

Typographic
symbols
Safety symbols
8
If anything is unclear, consult your safety officer or contact REHM's customer
service department.
You should also pay attention to the special notes regarding correct use set out
in the suppliers documentations.
National regulations regarding the operation of the unit are valid with no
restrictions .
Welding current sources may not be used to defrost tubes.
Correct use also covers the observation of the correct measures with regard to
mounting, removal and remounting, taking into service, operation and
maintenance as well as disposal. Please pay special attention to the
specifications in Chapter 2 Safety notes and Chapter 8.4 Correct disposal.
The unit may only be operated under the conditions set out above. Any other use
is not correct. The consequences are the responsibility of the operator.
1.3

Symbols used


Lists with bullets: General lists
 Lists with a square: Work or operational steps that must be carried out in the
sequence listed.
Cross-references: In this case, to Chapter 2.2 Warning symbols on the unit
Note!
... Refers to tips and other useful information.
The safety symbols used in this manual:  Chapter 2.1
 Chapter 2.2, Warning symbols on the unit
Bold is used for emphasis
Introduction