Hitachi YUTAKI M Bedienungsanleitung Seite 23

5.1 Water Drain Discharge Connection (Accessory)
When the base of the outdoor unit is temporarily utilized as a drain receiver and the drain water in
it is discharged, this drain boss is utilized to connect the drain piping.
Model
DBS-12L
5.1.1 Connecting procedure
1 Insert the plastic cap into the drain boss up to the extruded portions.
2 Insert the boss into the unit base up to the extruded portions.
3 Size of the drain boss is: Ø15 mm (O.D.)
4 A drain pipe should be field-supplied.

NOTE
• Do not use this drain boss set in a cold area, because the drain water may freeze.
• This drain boss is not sufficient to collect all the drain water. If collecting drain water is
completely required, provide a drain-pan that is bigger than the unit base and install it under the
unit with drainage.
Drain hole
Plastic cap
Push Push
PMEN0647 rev.0 - 11/2023
Plastic cap
≥ O.D. ∅ 15mm
Applicable model
RASM-(2/3)VR2E
Drain hole
Drain pipe
Plastic cap
5
15