10. Transport/transport lock/climbing stairs
10.1.
General information on transport
Only the tested and approved wheelchair and occu-
pant restraint system from AMF-Bruns may be used for
transporting the SIMPLY
cles for the transportation of the disabled In addition,
a 4-point restraint system from AMF-Bruns is required
for transport in motor vehicles For information on how
to correctly secure the force application point system
in the respective vehicle, please see the manufacture's
instructions and the following chapter 102 „Transport
with an AMF force application point system"
Warning!
Dangers due to incorrect fastening
of the transport safety device
If you attach the safety device for transport
in a vehicle to the wrong places on the product,
it cannot be transported safely
Never secure the transport safety device to the
frame or other unsuitable basic components!
10.2. Transport with an AMF force application point system
The SIMPLY
undercarriage was subjected to a crash
®
test as standard version with maximum fittings in ac-
cordance with ISO 7176-19 Some models are custom-
made and cannot be tested in a crash test Nonethe-
less, the custom-made model is also fitted with a force
application point system manufactured by AMF Bruns
Further information is available at wwwamf-brunsde
The undercarriage is marked on four points which
indicate the mounting points for the tension belts for
transportation with motor vehicles Only use the pro-
vided mounting points for strapping with tension belts
When fitted correctly, the head rest of the seat shell
is very robust, but cannot replace head rests fitted to
motor vehicles
Caution!
The SIMPLY
undercarriage has been
®
tested without an additional drive If an
additional electrical drive is to be added, then this
accessory is to be disassembled if the SIMPLY
dercarriage is to be transported in a motor vehicle
11. Maintenance plan
11.1.
Cleaning
Your interco product is made of high-quality and du-
rable materials which are easy to clean Please ob-
serve the following instructions for long durability of
the product:
Always keep the product dry, at temperatures be-
tween -10 and +40 °C This prevents corrosion
Sand or other dirt particles should not be allowed
to penetrate the product This could damage the
mechanics or - if applicable - the wheels
Never use the product in salt water
The cushions can be removed for cleaning and care
undercarriage in motor vehi-
®
un-
®
10.3. Transport on aircraft
When traveling by air, the product may only be trans-
ported without the user in the cargo hold of the aircraft
There are no further instructions or regulations for
transport in an aircraft We therefore strongly recom-
mend that you contact the airline before traveling by air
to clarify the transport options in each individual case
Caution!
Transport on aircraft
The user must never be in the device
when it is transported in the cargo hold
of an aircraft!
10.4. Climbing stairs
Stairs or high curbs can only be negotiated with the
assistance of two accompanying persons Assistants
are only permitted to grip the front frame tube and the
back brace of the frame, without lifting or carrying the
product when doing so
When ascending, the assistant behind the device pulls
the device up the step The assistant in the front sta-
bilizes the position by pressing the device equally on
both sides into the step
When descending, the assistant at the front brakes by
pressing the device evenly into the steps The assis-
tant behind holds the back brace, and stabilizes and
maintains the device in the correct position To prevent
damage, slowly roll the product down the steps Then
properly readjust the anti-tipping system (if installed)
Caution!
Risks when climbing stairs
If you hold or lift the product by its
attachments when climbing stairs, these
may tear off and the user may be injured
Do not hold the product by the push bar when
negotiating stairs
Never lift the product by the foot rest, the
wheels or the arm rests or other attached parts
Do not lift the product with the user sitting in it
11.1.1. Materials used
interco uses the following materials in the manufactur-
ing of medical devices and accessories:
Metals (aluminum, steel, stainless steel)
Plastics (POM, PA6, PTEG)
Beech wood (for therapy tray tables)
Foams (frame foam, polyurethane foam, hard
foam, azote foam, neoprene)
Upholstery fabrics (mesh material, Trevira CS
fabrics, artificial leather, Dartex)
Powder coatings
DIN and standard parts
All materials used are classified as harmless to health
49
MAINTENANCE PL AN