Profitec DRIVE Bedienungsanleitung Seite 62

Problem
Little or no crema on the top of
the coffee
Weak "body"
The machine is switched on,
but the machine does not work.
Translation of the original German user manual
Possible Cause
The grind is not fine enough
The coffee is too old
There is too much chlorine in
the water
The amount of ground coffee is
not enough
Shower screen is dirty
The grind is not fine enough
The coffee is old
The amount of ground coffee is
not enough
Shower screen is dirty
Display:
Water tank not correctly
inserted
Fixed water mode, but menu
setting "Tank Mode" = ON
(=water tank setting).
Machine does not draw water
from the pipe.
Troubleshooting
Use a finer grind. Tamp the
ground coffee more firmly.
Reduce the brewing pressure.
Use fresh coffee.
Use a chlorine filter.
Use the right coffee amount
(The marking inside the filter
basket can help you find the
right amount of coffee).
Clean the brew group.
Use a finer grind.
Use fresh coffee.
Use the right coffee amount
(The marking inside the filter
basket can help you find the
right amount of coffee).
Clean the brew group.
Fill the water tank
Switch on/off the machine.
Make sure that the floater in
the water tank is in the correct
position. (The side of the floater
with the magnet point must face
towards the inside of the
machine. The floater itself must
be inserted with the magnet
point on the upper part of the
floater).
Set the „Tank Mode" in the menu
to "OFF" (= fixed water setting).
ENGLISH
62