Fast Heating; Operating The Machine; Preparing The Machine - Profitec DRIVE Bedienungsanleitung

Make sure that "Advanced User Settings" is activated.
1. Press the left button
Temperature" appears on the display.
2. Navigate with the left button
the display. Confirm the selection with the right button
3. The offset value can now be adjusted in steps of 1 between -10 and +10.
The selection is confirmed after 5 seconds.
8.7

Fast Heating

To get your machine up and running faster, you can activate the Fast Heat-Up mode.
Make sure that "Advanced User Settings" is activated.
1. Press the left button
Temperature" appears on the display.
2. Navigate with the left button
the display. Confirm the selection with the right button
3. Now you have the option to choose between "ON" and "OFF". The
selection is confirmed after 5 seconds.
9.

OPERATING THE MACHINE

9.1

Preparing the machine

The switched-off machine is put into operation as follows:
Preparing a machine in water tank or permanent water supply modes
1. In water tank mode: Fill the water tank or check whether there is enough water in the water tank. In
fixed water connection mode: Ensure that there is always water pressure, but not more than 2 bar, in
the line.
2. Now turn on the machine, the ring LED lights up.
3. The heating time usually takes approx. 12-13 minutes, depending on the ambient temperature, with
"Fast Heating" activated.
4. When "Flush" is shown on the display, the user should flush until "Ready Go" is shown on the display.
To do this, keep the portafilter clamped and place a tall cup under the portafilter spout. As soon as
Translation of the original German user manual
and the right button simultaneously, "Brew
until "Offset Correction" appears on
and the right button simultaneously, "Brew
until "Enable Fast Heating" appears on
.
.
ENGLISH
54