Machine Installation; Preparation For Installation; Electrical Connection; Water Supply Connection - Profitec DRIVE Bedienungsanleitung

Voltages:
Power:
Water tank:
Measurements:
Measurements with portafilter:
Weight:
4.

MACHINE INSTALLATION

i
The installation must be carried out exclusively by a qualified specialist in compliance with
valid laws and according to the local regulations, technical requirements, and standards.
4.1

Preparation for installation

• Place the machine on an even and stable surface.
i
• Make sure that the machine is on a water-resistant surface in case of water spillage
or leakage.
• Never place the machine on hot surfaces.
4.2

Electrical connection

• Make sure that the local main voltage supply corresponds to the information given on
the type plate on the front panel of the espresso machine.
• Make sure that you use the correct power plug corresponding to your country.
• Plug the machine into a grounded socket only and do not leave it unattended.
i
• Do not roll or bend the power cord.
• Do not use an extension cord / do not use a multiple socket.
4.3

Water supply connection

Important
Ensure that the fixed water connection of your machine is connected to a potable water
supply having an operating pressure at least 100 kPa (1 bar) and does not exceed 200 kPa.
i
We recommend using a pressure regulator and a shut-off valve in case the operating
pressure exceeds 200 kPa (2 bar) or frequently fluctuates.
The shut-off valve should be easily accessible, so that the water flow may be stopped at
any time. Make sure that the shut-off valve is closed or turned off when the machine is
not in use to prevent any possible water leakage.
i
The machine is delivered in the water tank mode by default.
Translation of the original German user manual
EU: 230 V Frequency:
UK: 230 V
NZ: 230 V
AU: 230 V
US: 115V
JP: 100 V
1.600 W
ca. 2.8 l
B x T x H / 340 mm x 485 mm x 420 mm
B x T x H / 340 mm x 580 mm x 420 mm
31 kg
ENGLISH
EU: 50 Hz
UK: 50 Hz
NZ: 50 Hz
AU: 50 Hz
US: 60 Hz
JP: 50/60Hz
38