Changing The Preset Values; Stopping The Post-Drying Programme; Switching Off The Sauna Control Unit - Sentiotec PRO C2 Montage- Und Gebrauchsanweisungen

Instructions for use for the user
Door is opening – warning "door" appears in the display
– In "Standby for remote operation" mode:
To continue the mode, the door must be closed and the bottom knob must
be pressed twice.
► The countdown (30 seconds) appears again in the display.
– In ongoing operation or if remote start output is enabled (for coin-operated
units or door sensor system):
Acknowledgement takes place automatically when the door is closed.

10.12. Changing the preset values

You can change the preset values at any time during operation.
1. Turn the function selector 2 to the function you want to change.
2. Use the intensity selector 3 to set the preferred preset value.

10.13. Stopping the post-drying programme

After combined mode, the post-drying programme is started automatically. This
involves heating the sauna cabin to 80°C with the fan running. (Standard =
30 minutes – depending on the setting in the technician menu). In the intensity
display 4, the text "dry" is displayed and the temperature symbol flashes.
● Hold down the intensity selector 3 for three seconds (long press) to cancel
the post-drying program.
To prevent mould and rot from forming, the post-drying programme should
NOT be stopped.

10.14. Switching off the sauna control unit

● Press the ON/OFF switch 6, to switch off the sauna control unit.
► The lights on the function selector 2 go out, on the intensity selector
and on the intensity level indicator.
► The sauna control unit is switched off.
p. 40/47