Bosch 8 OptiMUM-Serie Gebrauchsanleitung Seite 60

en Troubleshooting
Fault
Display shows "FOR
SCALE" "STOP
1
MACHINE".
Display shows "OVER-
LOAD" or
"UNDERLOAD".
Display shows "OVER-
LOAD" or "UNDER-
LOAD" when using
SensorControl Plus.
Display shows "ADD
INGREDIENTS" al-
though ingredients
have already been ad-
ded. The automatic
programme cannot be
1
started.
1
Depending on the appliance specifications
60
Cause and troubleshooting
Scales were switched on while appliance was running.
Set the rotary switch to
1.
Wait for the appliance to stop before using the
2.
scales.
Display values of scales have not been observed.
▶ Observe the display values of the scales.
1
→ "Display values of scales", Page 51
Too much or too little of the ingredients has been ad-
ded for the programme selected.
▶ Add the ingredients according to the specified
1
quantities.
→ "SensorControl Plus", Page 53
Ingredients were added before the scales were activ-
ated.
Empty the bowl.
1.
Select the programme again.
2.
Wait for the scales to calibrate.
3.
a The display shows "0 g" or "0.00 lb".
Add the ingredients.
4.
⁠ .