Bosch 8 OptiMUM-Serie Gebrauchsanleitung Seite 50

en Timer
To exit the configuration menu, se-
7.
lect one of the following options:
Press and hold
‒
Start processing.
‒
9 Timer
You can read off the processing time
elapsed or preset a time.
Tip: You can also monitor times with
the timer, e.g. resting times for
dough.
9.1 Display values of timer
Observe the following values when
using the timer.
Display range
Display steps
Settings range
Settings steps
9.2 About the timer
To ensure optimum use of the timer,
note the following.
Notes
¡ If the timer is stopped or switched
off during processing, processing
will continue.
¡ When processing is started with
the timer running, the appliance
will end processing on expiry of
the remaining time.
¡ If you interrupt processing for less
than 3 minutes, the last values dis-
played are saved and will resume
if processing starts again.
Tips
¡ You can adjust the remaining time
using or
50
, or ⁠ .
0 seconds to 3
hours
1 second
5 seconds to 3
hours
5 seconds
at any time.
¡ Values will change faster if
is pressed and held down.
¡ You can change the volume of the
signal tones at any time.
→ "Overview of basic settings",
Page 49
9.3 Reading off and resetting
the processing time
Note
Display of the previous processing
time will not start
¡ if the processing time has been
preset.
¡ if the SensorControl Plus function
is used.
Set the rotary switch to the re-
1.
quired speed.
a The display shows "TIME" and the
previous processing time.
To reset the display to "00:00",
2.
press and hold
9.4 Processing ingredients
with the timer
Requirement: The appliance is pre-
pared and the ingredients have been
added.
→ "Processing ingredients with tools",
Page 48
If the display is switched off, press
1.
any button.
Press ⁠ .
2.
a The display shows "TIMER" and
"00:00".
Use or to set the required
3.
duration.
Set the rotary switch to the re-
4.
quired speed.
a The display shows the remaining
processing time.
a Once this time has elapsed, a sig-
nal tone sounds and the display
shows "END" "TIMER".
or
⁠ .