Werbung
Verfügbare Sprachen
Verfügbare Sprachen
en Scales
10.2 Weighing ingredients
Requirements
¡ The bowl is inserted or an access-
ory is fitted.
¡ The rotary switch is set to
¡ The display is activated.
Press
and do not touch the ap-
1.
pliance again.
a The scales will be calibrated.
a The display shows "- - - - -".
Wait for calibration to finish.
2.
a The display shows "0 g" or
"0.00 lb".
Add the required ingredient.
3.
a The display shows the weight.
To weigh further ingredients, select
4.
one of the following options:
Add further ingredients and read
‒
off the total weight.
Repeat the process and weigh
‒
the ingredients individually.
10.3 Presetting the weight
Requirements
¡ The bowl has been inserted.
¡ The rotary switch is set to
If the display is switched off, press
1.
any button.
Press
and do not touch the ap-
2.
pliance again.
a The scales will be calibrated.
a The display shows "- - - - -".
Wait for calibration to finish.
3.
a The display shows "0 g" or
"0.00 lb".
Press
.
4.
a The display shows "100 g" or
"0.20 lb".
Use
or
to set the required
5.
weight.
Add the required ingredient to the
6.
bowl.
52
a The display shows the quantity by
which the weight is short, e.g.
65 g.
a A recurring signal tone will sound
from a short weight of 40 g or
.
0.08 lb.
Continue adding the ingredient
7.
little by little.
a The lower the weight that is short,
the faster the signal tone will
sound.
a When the preset quantity is
reached, the signal tone will stop.
Note: If the preset quantity is ex-
8.
ceeded, the signal tone will sound
continuously. The display shows
the excess weight added as a neg-
ative value, e.g. -40 g.
Take the excess weight added
away again.
To end weighing, press and hold
9.
Tip: You can change the volume of
the signal tones at any time.
→ "Overview of basic settings",
Page 49
10.4 Resetting scales
.
If an error message appears or unac-
customed measured values are dis-
played, reset the scales.
Press and hold
1.
a The display shows "OptiMUM"
To restart the scales, press
2.
Note: If the scales still do not work
properly, disconnect the appliance
from the power supply for a while
and then start the scales again.
or start processing.
.
.
Werbung
