Operation And Signal Display - perma-trade solvent primus 2.1 Bedienungsanleitung

For water tappings of more than 1 l/min for PT-P25-2.1 / PT-PV25-2.1 or 2.5 l/min for PT-P40-2.1,
the row of blue LEDs indicates the current flow rate. In contrast to the total flow rate, the row of
LEDs works as a running light.
Flow rate PT-P25-2.1 or PT-PV25-2.1
1. LED: 1 to 6 l/min
2nd LED: from 6 to 12 l/min
3rd LED: from 12 to 18 l/min
4. LED: from 18 to 24 l/min
5. LED: from 24 l/min
If the running light does not come on at a water withdrawal of more than 1 l/min for PT-P25-2.1 /
PT-PV25-2.1, 2.5 l/min for PT-P40-2.1, 5l/min for PT-P40-2-2.1 or 7.5l/min for PT-P40-3-2.1, the
Hall sensor cable must be checked for correct seating and/or the flow turbine must be checked
for free movement (see chap. 0).

8. OPERATION AND SIGNAL DISPLAY

1. display Display
Blue LED on steady light:
The unit is ready for operation.
1st to 5th blue LED as flashing light:
Water is taken out and treated electrodynamically. The more LEDs flash, the
is greater than the current water withdrawal (see Chap.0).
Blue LED on steady light:
When treatment is inactive (no water flow), the row of 5 blue LEDs shows
indicates the remaining capacity of the treatment unit.
5 LED residual capacity 80 - 100%
4 LED residual capacity 60 - 80%
3 LED residual capacity 40 - 60%
2 LED Residual capacity 20 - 40
1 LED residual capacity < 20
Red LED on steady light and acoustic signal:
Flow PT-P40-2.1
1st LED: 2.5 to 12 l/min
2nd LED: from 12 to 24 l/min
3rd LED: from 24 to 36 l/min
4. LED: from 36 to 48 l/min
5. LED: from 48 l/min
71