Installation Conditions / Installation Instructions - perma-trade solvent primus 2.1 Bedienungsanleitung

•
4 Pressure bodies incl. active unit and head with corrosion-resistant coating and easy-to-
install connection technology
•
2 double connection flanges incl. flow turbine
•
Venting hose
•
2 control electronics incl. Hall sensor with mains connection; 1 x with potential-free output
•
4 shut-off valves
•
Central backflow preventer
•
Operating instructions and commissioning protocol
•
2 Seal kits P-DS40-2.1
permasolvent primus PT-P40-3-2.1 consisting of 3 limescale protection systems PT-P40-2.1
mounted on an aluminium stand with each:
•
6 Pressure body incl. active unit and head with corrosion-resistant coating and easy-to-
install connection technology
•
3 double connection flanges incl. flow turbine
•
Venting hose
•
3 control electronics incl. Hall sensor with mains connection; 1 x with potential-free output
•
4 shut-off valves
•
Central backflow preventer
•
Operating instructions and commissioning protocol
•
3 Seal kits P-DS40-2.1
5. INSTALLATION CONDITIONS / INSTALLATION
INSTRUCTIONS
The installation must be carried out by a licensed company and must comply with the
comply with local installation regulations. The electronics housing may only be opened by
qualified service personnel.
To protect the permasolvent primus 2.1 from particulate contamination, a DVGW or SVGW
approved drinking water fine filter (e.g. permaster) must be installed in the domestic installation
upstream of the unit.
If the inlet pressure is higher than 10 bar, a DVGW or SVGW approved pressure reducer must be
installed in front of the unit. To protect the installation site in the event of water damage, a
sufficient floor drain should be provided! The installation site must be frost-proof! The
permasolvent primus 2.1 must be protected from all types of chemicals and heat sources above
40 °C!
Attention: For hygienic reasons, the permasolvent primus2.1 must always be
The unit must be supplied with mains voltage. Therefore, even in times of prolonged absence,
please connect the unit to the mains.
do not disconnect from the mains.
66