Bus Status Display - TR-Electronic CK-58 Benutzerhandbuch

6.4 Bus status display

The measuring system has two LEDs in the connection hood. A red LED (Bus Fail) to
display faults and a green LED (Bus Run) to display status information.
When the measuring system starts up, both LEDs flash briefly. The display then
depends on the operational state.
= ON
= OFF
= 1 Hz
= 10 Hz
LED, green
LED, red
Corresponding measures in case of an error see chapter "Troubleshooting and
diagnosis options", page 107.
Printed in the Federal Republic of Germany
10/01/2014
Type with cable glands
Ready for operation
Supply absent, hardware error
Parameterization or configuration error in PNO-compatible nominal
configuration. Data have been corrected.
Irreparable parameterization or configuration error
No error, bus in cycle
Measuring system is not addressed by the master, no data exchange
Non-recoverable measuring system fault
TR - ECE - BA - DGB - 00036 - 10
Type with connectors
Bus Run
Bus Fail
 TR-Electronic GmbH 2004, All Rights Reserved
Page 79 of 115