Bosch MultiTalent 3 MCM3 Serie Gebrauchsanleitung Seite 25

Smart tool detection (MCM3P...)
Each speed setting is marked with a different
colour (grey and red). You can also find this
colour coding system on the accessories.
The accessories are automatically
connected with the correct speed setting.
Low speed, grey
with drive shaft
For tools and cutting discs.
High speed, red
without drive shaft
For blender and universal cutter.
Preparation
■ Place the base unit on a smooth, stable
and clean surface.
■ Pull the cable out of the base unit to the
required length.
Important information
– Only use the rotary switch to switch the
appliance on or off.
– Never switch the appliance off by rotating
the bowl, the blender or a tool.
– Do not switch the appliance on unless
tools or accessories have been completely
attached.
Bowl with accessories/tools
Warning!
When working with the bowl, the appliance
cannot be switched on until the bowl has
been attached and the lid has been attached
and screwed on tight.
Universal blade
for cutting, mincing, mixing and
kneading.
Kneading hook
for kneading dough and mixing in
ingredients that ought not be cut (e.g. raisins,
chocolate chips).
Beating disc
for cream, egg white and
mayonnaise.
Recommendation for an optimum result:
■ Use cream with a minimum fat content of
30% and a temperature of 4-8 °C.
Printed on 100% recycled paper
Fig. B
■ Attach the bowl (match arrow on bowl to
dot on appliance .) and rotate as far as
possible in a clockwise direction (,).
■ Insert the tool holder into the bowl.
■ Put the universal blade, beating disc or
kneading hook on the tool holder and
release.
Note the position of the tools when
inserting them. Press tools all the way
down.
Warning!
Do not add ingredients until the tools have
been inserted.
■ Add the ingredients.
■ Attach the lid with the pusher (match arrow
on lid with dot on bowl .) and rotate in a
clockwise direction (,). The lid lug must be
fully engaged in the slot in the bowl handle.
■ Insert the mains plug.
■ Set the rotary switch to the desired setting.
■ To add more ingredients, set the rotary
switch to P.
■ Remove the pusher and add ingredients
through the filler opening. The pusher can
be used as a measuring cup.
Cutting discs
Reversible slicing disc, thick/thin
Cutting food into thick or thin slices,
e.g. fruit and vegetables.
Marking:
■ 1 = thick slices
■ 3 = thin slices
Note: Not suitable for processing hard
cheese, bread, rolls or chocolate.
Tip: Only cut up cooked potatoes once they
have cooled down.
Reversible shredding disc,
coarse/fine
Shredding food coarsely or finely,
e.g. fruit, vegetables or cheese such as
Gouda or Edam.
Marking:
■ 2 = coarse side
■ 4 = fine side
Note: Not suitable for processing nuts or
hard cheese, e.g. Parmesan.
Tip: Shred soft cheese with the coarse side
only.
Operation en
25