Qualified Personnel; Installation And Commissioning - BWT AQA drink 1 CAS Bedienungsanleitung

» non-compliance with the information given
in these installation and operating instruc-
tions;
» use for purposes other than the intended
purpose;
» incorrect or faulty installation;
» incorrect commissioning, operation and
maintenance;
» use of components that have not been ap-
proved;
» non-performance of the prescribed service
and replacement work;
» unauthorised technical
changes or modifications.
6.2 RESPONSIBILITY OF THE
OPERATING COMPANY
» The installation and operating instructions
must be kept in the immediate vicinity of
the device and must be accessible at all
times.
» The device may only be operated in a tech-
nically correct and operationally safe con-
dition.
» The information in these installation and
operating instructions must be complied
with, at all times.
6.3 LICENCE TERMS
The installation and operating instructions are
protected by copyright. The transfer of these
instructions to third parties, reproduction of
any kind – including extracts – as well as the
exploitation and/or disclosure of the content
are not permitted without the written consent
of the manufacturer. Any breach or infringe-
ment will result in liability for damages. We re-
serve the right to assert further claims.
Note! With the acquisition of the
AQA drink 1 CAS water dispenser,
the user receives an exclusive,
nontransferable right to use the software in-
stalled by the manufacturer.
6.4

QUALIFIED PERSONNEL

Only trained personnel and staff may install,
put into operation and maintain the water dis-
penser.
» The trained person has been informed of
the tasks entrusted to him/her, and of pos-
sible dangers in the event of improper use
or behaviour.
»
and repairs.
or mechanical
7.
• Technical rules for drinking water installa-
• Ordinance relating to the quality of water
All delivered AQA drink 1 CAS water dispens-
ers comply with the EU Directives 2011/65/
EU and 2015/863/EU on the restriction of
the use of certain hazardous substances in
electrical and electronic equipment.
Prior to installation, read "4. Technical data"
on page 25 and "6. Operating and safety
instructions" on page 28.
Set up and operate the device in a vertical
position.
Do not place the device directly against a
wall. Leave a distance of at least 15 cm.
7.1
Remove your device from the packaging.
Check that the shipment is complete and has
not been damaged in transit. Defective parts
must be replaced immediately.
7.2
Place the device on a level surface or on the
AQA drink 1 CAS base (optional).
Table-top unit
Position the drip tray in the intended place be-
low the water outlet.
Trained persons are in a position to install,
put into operation and maintain the device
on due to of their technical training, know-
ledge and experience as well as knowledge
of the applicable regulations.
Note! Define clear guidelines for
the relevant responsibility for ope-
ration, installation, maintenance
INSTALLATION AND
COMMISSIONING
Note! The following laws must be
observed while installing and op-
erating of the system:
tion.
intended for human consumption (drink-
ing water ordinance).
UNPACKING THE
WATER DISPENSER
PREPARING THE
WATER DISPENSER
BWT AQA drink 1 CAS
EN
29