Aqa Drink 1 Cas Hygiene Checklist - BWT AQA drink 1 CAS Bedienungsanleitung

Error
Water leakage
Drip cup LED flashes, an
acoustic signal sounds
and water dispensing is
not possible
UV LED indicator on the
control panel flashes, an
acoustic warning signal
sounds and no water
withdrawal possible
EN
11.

AQA DRINK 1 CAS HYGIENE CHECKLIST

Component
External Cleaning
housing and
front panel
Water outlet Disinfection
parts
Drip tray, grid Cleaning
or waste water
tank
Emptying
Cooling fins Cleaning
Water circuit in Disinfection
the water
dispenser
Filter Replacement
CO2 safety Check the gas pressure
check reducer and check the
entire device for leaks
36 BWT AQA drink 1 CAS
Cause
Water pipes in the
device are defective
Wastewater tank is full
Leakage is detected
UV lamp not connected
correctly or defective
Frequency of action
Type of
action
daily
4
4
4
Error recovery
Close the water tap, disconnect the device from
the power supply, then contact a service
technician
Empty the waste water tank. If necessary,
disconnect the appliance from the mains for
10 seconds and reconnect it.
Contact service technician.
Disconnect the appliance from the mains, unplug
and reconnect the plug the connector in and out
again and switch the unit back on. If the UV lamp
does not work, disconnect the unit from the
mains again. If the problem persists, contact the
service technician.
weekly annually
Customer/operating company
(remove lime marks from the
surface of the device using a
descaling spray and then clean
and disinfect using a sanitary
spray)
Customer/operating company
(clean and disinfect using a
sanitary spray)
Customer/operating company
(under running water with
4
standard mild cleaner)
Customer/operating company
Authorised, qualified technical
4
staff
Authorised, qualified technical
staff
4
Authorised, qualified technical
4
staff
annually
or after
capacity
has been
used up
Authorised, qualified technical
4
staff (only by competent
(or every
person)
2 years)
To be performed by