Carbon Brushes - EINHELL TC-TS 2000 U Originalbetriebsanleitung

10. Cleaning, maintenance and ordering of spare parts
Danger!
Always pull out the mains power plug before starting any cleaning
work.
10.1 Cleaning
Keep all safety devices, air vents and the motor housing free of
•
dirt and dust as far as possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low pressure.
We recommend that you clean the device immediately each time
•
you have finished using it.
Clean the equipment regularly with a moist cloth and some soft
•
soap. Do not use cleaning agents or solvents; these could attack
the plastic parts of the equipment. Ensure that no water can seep
into the device. The ingress of water into an electric tool increa-
ses the risk of an electric shock.

10.2 Carbon brushes

In case of excessive sparking, have the carbon brushes checked
only by a qualifi ed electrician.
Danger! The carbon brushes should not be rep laced by anyone
but a qualifi ed electrician.
10.3 Maintenance
There are no parts inside the equipment which require additional
maintenance.
Anl_TC_TS_2000_U_SPK9.indb 83 Anl_TC_TS_2000_U_SPK9.indb 83
GB
- 83 -
28.04.2020 14:40:10 28.04.2020 14:40:10