EINHELL TC-TS 2000 U Originalbetriebsanleitung Seite 79

The parallel stop (7) has to be mounted in the guide rail (28) of
•
the saw table (1).
The parallel stop (7) can be set to the required dimension with
•
the help of the scale (22) on the guide rail (28).
You can clamp the parallel stop in the required position by pres-
•
sing the eccentric lever (12).
7.3.3 Setting the stop length (Fig. 17, 18)
The stop rail (23) can be moved in longitudinal direction in order
•
to prevent the workpiece from becoming jammed.
Rule of thumb: The rear end of the stop comes up against an
•
imaginary line that begins roughly at the center of the blade and
runs at an angle of 45° to the rear.
Set the required cutting width
•
- Slacken the knurled screws (26) and push the stop rail (23) for-
ward until it touches the imaginary 45° line.
- Retighten the knurled screws (26).
Warning! The gap between the saw table (1) and the underside of
the stop rail (23) must not be too large in order to prevent the ma-
terial getting jammed. To adjust the distance, the parallel stop (7)
must be fastened fi rst using the eccentric lever (12). Then slacken
the knurled screws (26), lower the stop rail (23) down to the saw ta-
ble (1) and secure the knurled screws (26) again afterwards.
7.4 Cross stop (Fig. 20)
The cross stop (14) has to be used when making cross cuts in woo-
den workpieces.
Slide the cross stop (14) into the slot (21) of the saw table.
•
Undo the locking screw (20).
•
Turn the stop rail (24) until the arrow points to the angle required.
•
Re-tighten the fastening screw (20).
•
Check the gap between the stop rail (24) and the saw blade (4).
•
Warning! Do not push the stop rail (24) too far toward the blade.
•
The distance between the stop rail (24) and the blade (4) should
Anl_TC_TS_2000_U_SPK9.indb 79 Anl_TC_TS_2000_U_SPK9.indb 79
GB
- 79 -
28.04.2020 14:40:10 28.04.2020 14:40:10