EINHELL TC-TS 2000 U Originalbetriebsanleitung Seite 76

pressure.
Caution! Turn the screw (15) in the direction of rotation of the saw
•
blade.
Take off the outer flange and pull the old saw blade (4) off the in-
•
ner flange.
Clean the blade flange thoroughly before fitting the new blade.
•
Fit and fasten the new saw blade (4) in reverse order.
•
Important! Note the running direction. The cutting angle of the
•
teeth must point in running direction, i.e. forwards (see the arrow
on the blade guard).
Refit and set the splitter (5) and the saw blade guard (2) (see
•
6.5.)
Check to make sure that all safety devices are properly mounted
•
and in good working condition before you begin working with the
saw again.
Warning! Every time that you change the saw blade, check that
•
the saw blade guard (2) opens and closes again in accordance
with requirements. Also check that the saw blade (4) spins freely
in the saw blade guard (2).
Warning! Every time that you change the saw blade (4), check to
•
see that it spins freely in the table insert (6) in both perpendicular
and 45° angle settings.
Warning! You should replace the table insert (6) immediately
•
whenever it is worn or damaged (see 6.4).
Warning! The work to change and align the saw blade (4) must
•
be carried out correctly.
6.7 Putting away loose parts (Fig. 15)
When not in use, the parallel stop (7) and push stick (3) can be
•
secured as shown in Fig. 15a.
The two wrenches (38+39) and the additional saw blade (55)
•
can be secured as shown in Fig. 15b.
The cross stop (14) can be secured as shown in Fig. 15c.
•
Anl_TC_TS_2000_U_SPK9.indb 76 Anl_TC_TS_2000_U_SPK9.indb 76
GB
- 76 -
28.04.2020 14:40:10 28.04.2020 14:40:10