EINHELL TC-TS 2000 U Originalbetriebsanleitung Seite 74

Then tighten the screw connections referred to in 6.2. Use both
•
the wrenches (38) and (39) to do this.
6.3 Standing the bench-type circular saw upright
(Fig. 2, 7-9)
Turn the machine over so that it stands on its legs.
•
The bench-type circular saw must be stood on a flat surface.
•
Then tighten all loose screw connections. Use both the wrenches
•
(38) and (39) to do this.
Screw the additional legs (37 to the rear legs (29) so that they
•
point towards the rear of the machine. Us the screws (54),
washers (49) and nuts (51) to fasten them.
Warning! Don not fit the additional legs (37) too far away from the
•
surface on which the machine stands; they are intended to provi-
de protection against tipping over.
Remove the screw (53) from the shaft (25).
•
Slide the hand wheel (8) and then the crank (10) onto the shaft
•
(25) as shown in Fig. 9.
Important! The shaft (25) and the crank (10) engage with a posi-
•
tive fit, i.e. the flat surface on the shaft (25) and the flat surface in
the hub of the crank (10) must lie on top of each other to enable
the crank (10) to be slid on.
Secure the hand wheel (8) and crank (10) with the screw (53).
•
6.4 Changing the table insert (Figure 12)
To prevent increased likelihood of injury, the table insert should
•
be changed whenever it is worn or damaged.
Remove the countersunk head screws (17).
•
Remove the worn table insert (6) by pulling it out through the
•
opening at the back past the splitter (5) and the saw blade (4).
Fit the replacement table insert by following the above in reverse.
•
Anl_TC_TS_2000_U_SPK9.indb 74 Anl_TC_TS_2000_U_SPK9.indb 74
GB
- 74 -
28.04.2020 14:40:09 28.04.2020 14:40:09